连续式提升机的点检、保养、注意事项 -尊龙app

欢迎来到- 无锡市长荣输送机械有限公司 的官方网站!
服务热线:0510-8338 0342联系尊龙在线登录
新闻资讯
新闻资讯您当前位置:尊龙在线登录首页 > 新闻资讯
连续式提升机的点检、保养、注意事项
发布者:admin  点击:2533

1.由于设备长期运行,故需要经常对提升机的易损件,耗材部件进行检查、保养、更换等操作。
2.该系统中的主要部件均采用进口件,设计使用寿命均大于5年,或更长。例如:plc、空气开关、电机等元器件;但如继电器器、行程式开关、按扭、选择开关、等频繁动作的部件可能出现磨损、打火、烧焦或接触不良等问题,这些均需要设备维护和使用人员在设备长期工作过程中不断地保养检查。
3.如果设备长期没有使用,在再次使用前一定手动点检,对可能会造成人身伤害、设备损坏、危险异常情况一定要仔细检查、定期更换损耗品。
4.请每周对控制柜、远程分线盒、外露部件(如行程开关、光电开关、接近开关先等)做清洁保养工作,这样可以防止因为尘埃、不洁物对以上元器件造成误动、假信号、或影响动作精度等危害。
5.每月对控制柜、远程分线盒内部作定期清洁、视检等工作,对接线端子、接触器、继电器等部件的按线、触头进行仔细检查,以防止有打火、烧焦、粘死、松脱等异常问题。
6.每二个月需对外部电气部件进行检查:行程开关有无松动、脱落、压死、撞损;升降机电机刹车动作是否良好,以防造成马达煞车抱死,或失灵等故障。
7.每三个月对整个系统设备的所有部件、部品、尤其是外部信号源、执行机构做仔细的点检、保养、更新;电机是否有噪声或需添加机油;电机刹车是否需要调节等。
8.每半年需对设备进行停机整修;对主要部件的各种性能、参数,需重新做评估测试;对电气线路的安全性、可靠性,重新检查;系统接地、电机绝缘等,做仔细检查,及易损件的维修更换。

中译英:
1 because the device runs for a long time, so often need to equipment wearing parts, supplies components are examined, maintenance, replacement and other operations.
2 systems in which the main components are imported parts, the design service life is more than 5 years, or longer. for example: plc, air switch, motor and other components; but such as relay, switch, button, line program selector switch, and other frequent action parts may wear, ignition, burning or poor contact problems, all these need equipment maintenance and use of personnel in the equipment working process of continuous maintenance check.
3 if the equipment for a long time does not use, before reuse certain manual inspection, likely to cause bodily injury, damage to equipment, dangerous anomalies must be examined carefully, the periodic replacement of the consumer goods.
4 weekly on the control cabinet, remote junction box, the exposed parts ( such as a travel switch, photoelectric switch, close to switch to ) do cleaning and maintenance work, so as to prevent dust, because the unclean on the above components causing malfunction, false signal, or affect the movement accuracy and other hazards.
5 monthly on the control cabinet, remote junction box internal periodic cleaning, inspection work, the terminal, contactor, relay and other parts of the press line, contact check carefully, to prevent ignition, burning, stuck, loose abnormal problem.
6 every two months to be on the external electrical components are examined: the travel switch is loose, falling off, crushed, collision damage; elevator motor brake action is good or not, to avoid causing motor brake lock, or failure fault.
7 every three months for the whole system to all parts of the apparatus, parts, especially the external signal source, implementing agencies do careful inspection, maintenance, update; whether the motor noise or need to add oil; the motor brake need adjustment.
8 per annum for equipment downtime refurbishment; for main components of various properties, parameters, the need to do the evaluation test of electrical circuit; safety, reliability, reexamine; system grounding, electrical insulation, making a careful examination, and wearing parts repair replacement.
(图/文www.changrong-jx.com)

上一页:长荣输送机械之装载机故障产生原因
下一页:长荣输送机械之装载机主要参数
关于长荣
尊龙app的简介
资质荣誉
尊龙棋牌的文化
公司客户
视频中心
企业新闻
技术文章
公司新闻
行业新闻
尊龙app的产品展示
钛材产品
食品行业输送机
螺旋输送机系列
压包机
螺旋给料机
斗式提升机系列
刮板输送机
蛇形链板输送机系列
蛇形链斗输送机系列
 
振动输送机系列
松香开罐机
螺旋装载机
混合搅拌机
分料机
破拱机
阀系列
辊子输送机系列
手动投料装置
联系长荣
人力资源
客户反馈
联系尊龙在线登录

扫描二维码关注长荣