皮带输送机安全操作规程 -尊龙app

欢迎来到- 无锡市长荣输送机械有限公司 的官方网站!
服务热线:0510-8338 0342联系尊龙在线登录
新闻资讯
新闻资讯您当前位置:尊龙在线登录首页 > 新闻资讯
皮带输送机安全操作规程
发布者:admin  点击:6556

1.移动式皮带运输机运转作业前,应将行走轮用三角木对称楔紧。固定式皮带运输机,应安装在牢固的基础上。
2.起动前,调整好办减速这松紧度,带扣应牢固,轴承、齿轮、链条等传动部件应良好,托轮和防护装置应齐全,电器接地(接零)保护良好,输送带与滚筒宽度应一致。
3.应先空载起动,待运转正常后,方可均匀装料,不得先装料后起动。
4.作业中,应随时注意机械的运转情况如发现输送带有松驰或走偏现象,应停车进行调整或修理。严禁在运转中进行修理和调整。
5.作业时,严禁任何人员从皮带运输机下面穿过或跨越输送带。输送带打滑时,不得用手抖动拉动。
6.输送大块物料时,输送带两侧应加装档板或栅栏等防护装置。
7.运转中需要停机时,应先停止装料,待输送带上料卸尽后,方可停机。
8.遇电源突然中断或其它原因突然停车,应立即切断电源,然后将皮带上的物料清除掉,等来电或排除故障后,再接通电源启动运转。
9.停车前必须先与有关方面联系,待输送带上的物料完全卸掉后,方可停机。
10.停机后应切断电源,锁好电源开关箱,对机械各部进行保养。用防雨护罩将电动机盖好。

中译英:
1 mobile belt conveyor running before the work, should the walking wheel with wooden triangle symmetric wedge. fixed belt conveyer, should be installed on a solid basis.
2 before starting, adjustment of the tightness of the easy reduction, buckle should be firm, bearing, gear, chain and other transmission parts should be good, the supporting wheel and the protective device should be complete, electrical grounding ( zero) to protect the good, the belt and the roller width should be consistent.
3 first no-load starting, to be in normal operation, can be uniformly charging, not to charge after starting.
4 work, should always pay attention to mechanical running condition such as found in conveyor with relaxation or off phenomenon, should stop adjustment or repair. is strictly prohibited in the operation for repair and adjustment.
5 operations, and forbids any personnel from the belt conveyor below through or across the conveyor belt. the conveying belt, not to hand shake pulling.
6 conveyor bulk materials, two sides of the conveyer should install baffles or fence protective device.
7 operation need to stop, should stop charging, stay on the conveyor belt after discharge, before shutdown.
8 in the event of power supply is suddenly broken or other causes of sudden stop, should be immediately cut off the power supply, then the belt material removed, such as call or after troubleshooting, and then turn on the power supply to start running.
9 parking must be concerned with relation to the conveyor belt, the material is fully unloaded, before shutdown.
10 stops should be cut off the power supply, power lock switch box, the department of mechanical maintenance. rainproof cover for motor cover.
(图/文www.changrong-jx.com)

上一页:皮带输送机安装前准备和检测调整
下一页:hl链型斗式提升机链轮的改进
关于长荣
尊龙app的简介
资质荣誉
尊龙棋牌的文化
公司客户
视频中心
企业新闻
技术文章
公司新闻
行业新闻
尊龙app的产品展示
钛材产品
食品行业输送机
螺旋输送机系列
压包机
螺旋给料机
斗式提升机系列
刮板输送机
蛇形链板输送机系列
蛇形链斗输送机系列
 
振动输送机系列
松香开罐机
螺旋装载机
混合搅拌机
分料机
破拱机
阀系列
辊子输送机系列
手动投料装置
联系长荣
人力资源
客户反馈
联系尊龙在线登录

扫描二维码关注长荣